Dolo Wall Grip
home > Dolo Wall GripSpecification:
| Application Data | Tools | Putty knife |
| Thinning | Potable Water | |
| Thinner ratio | 35-40% by volume | |
| Technical Data | Finish | Matt |
| *Coverage | Approx 35 sqft./mm/kg Maximum thickness of 1st coat (layer) 1.5 mm and maximum thickness of 2nd coat (layer) 1.0 mm.* Coverage achieved depends on the base surface condition and finished thickness. |
|
| Surface dry | 30 min at 30°C ± 2°C & RH 60 ± 5% | |
| Recoat time | 4 (Hot Season) – 12 (Cold Season) Hours | |
| Pot Life | 2 - 2.5 hours. | |
| Pack Size | 1, 5, 10, 20 & 40 kg |
Product description
Dolo Wall Grip Wall Putty is a white cement based fine powder which provides an ideal base for concrete / cement plastered walls and ceilings. It is damp resistant and provides a smooth finish for further application of all kinds of paints. Its water repelling properties prevents flaking of your expensive paints. This gives better compatibility, adhesive-strength and a long-life to Dolo Grip Wall Putty.
Preparation of Dolo Grip Wall Putty paste
Take required quantity of Dolo wall grip Wall Putty in a pan. 35-40% water by volume is required to prepare paste of good consistency. Mix half of required water quantity into it. Knead/Mix the Putty & wait for few minutes. Mix remaining quantity of water to get desired consistency. Mix vigorously for 5-10 minutes for making a lump-free and uniform paste. Mix the product in such quantities that it should be used within 2 hours of preparation. Mixing may be done manually or by using a suitable electric mixer.
Application of Dolo Grip Wall Putty
Ensure that surface is totally clean Ensure that surface plastered or made with cementitious material. The surface should be moderately rough and in just-wet condition. Apply 1st coat of Dolo Grip (1.5 mm thickness) using a blade / spatula on the wall with a "bottom to up" configuration Apply 2nd coat of Dolo Grip (1.0 mm thickness) preferably after 4 hours in summers and after 12 hours in winters. Second coat shall be applied "horizontally" to even out application marks of 1st coat, if any. Allow complete drying for 3 days and then use a fine emery paper to remove application marks, if any.
Recommended usage:
Dolo Grip can be used in concrete, rendered walls, calcium silicate bricks, aerated light-weight blocks, hollow blocks, pre-cast walls, concrete ceilings etc.
